QC Lubricants
CAGE CODE 9Y364
7360 Milnor St. Philadelphia, PA 19136
(215) 333-4187
Direct Line

Toll Free
With Extension (800) 887-2436
For Technical Assistance:
Dial Extension 203 for Stan Jakubowski
For Sales:
Dial Extension 211 for Lu Ann Quinn or 224 for Lindsay Romero
Email Lu Ann Quinn  ♦   Email Lindsay Romero


Home

We actively supply a comprehensive line of MIL-SPEC  and commercial lubricants.

 

Back to Tectyl Main Page
Mil-Specs
Products
MSDS
Product Shelf Life
PDS and Other Docs
Chemical.net

QC BLU DEF Diesel Exhaust Fluid

ExxonMobile
Castrol
Shell
Valvoline
Anderol
LHB Industries
 

  

advanced

  Tectyl 506 G 

Tectyl 506 G

Description
TECTYL 506-G is solvent cutback, wax base, thixotropic, dark amber, gelled corrosion preventive compound.

TECTYL 506-G is recommended for the long term protection of ferrous and non-ferrous metals, as an underbody coating of autos, trucks, trailers, etc.

TECTYL 506-G cures to a relatively firm, dark amber, resilient, tough film.

Tecyl 506G

Tectyl

Surface Preparation:
The maximum performance of TECTYL 506-G can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale. Valvoline recommends that the metal substrate temperature be 10-35 °C at the time of product application.

Application:
TECTYL 506-G is formulated to be used as supplied. Ensure uniform consistency prior to use. Continued stirring is generally not required. If the product thickens due to cold storage or loss of solvent during use, contact Valvoline. DO NOT THIN TECTYL 506-G. Incorrect thinning will affect film build, dry time and product performance. Valvoline recommends that the ambient and product temperature be 10-35 °C at the time of product application. TECTYL 506-G can be applied by airless spray or brush.

Removal:
TECTYL 506-G can be removed with mineral spirits or any similar petroleum solvent, hot alkaline wash or low pressure steam.

Storage:
TECTYL 506-G should be stored at temperatures between 10-35 °C. Mild agitation is recommended prior to use. Due to its composition TECTYL 506-G can be subject to postproduction viscosity changes during storage.
Under proper storage conditions TECTYL 506-G can have a shelf life of 3 years minimum.

Caution:
Adequate ventilation is required for cure and to ensure against formation of combustible liquid. THE PARTIALLY CURED FILM SHOULD NOT BE EXPOSED TO IGNITION SOURCES SUCH AS FLARES, FLAMES, SPARKS, EXCESSIVE HEAT OR TORCHES. Refer to Valvoline’s Material Safety Data Sheet for additional handling and first aid information.

Note:
The addition of any product over or under this coating is not recommended. The use of additional coatings could result in chemical incompatibility, thus affecting the performance of this coating as stated in the Typical Properties section. If a primer, other than a Valvoline recommended product is required, written authorization must be obtained from Valvoline.

 

Back to Tectyl main Page