QC LubricantsCAGE CODE 9Y364
7360 Milnor St. Philadelphia, PA 19136
(215) 333-4187 Direct Line
Toll Free With Extension (800) 887-2436
For Technical Assistance: Dial Extension 203 for Stan Jakubowski
For Sales: Dial Extension 211 for Lu Ann Quinn or 224 for Lindsay Romero
Email Lu Ann Quinn ♦ Email Lindsay Romero
We actively supply a comprehensive line of MIL-SPEC and commercial lubricants.
QC Lubricants carries Tectyl 155FF in Pails and drums.
TECTYL 155FF Pigmented is a firm film, solvent cutback, thixotropic corrosion preventive compound designed for excellent protection of ferrous metal against the formation of rust. It is recommended for applications where a firm film coating with weathering is required.
The maximum performance of TECTYL 155FF Pigmented can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale. Daubert Chemical Company recommends that the metal substrate temperature be 50-95°F (10-35°C) at the time of product application.
TECTYL 155FF Pigmented is formulated to be used as supplied. Ensure uniform consistency prior to use. Continued stirring is generally not required. If the product thickens due to cold storage or loss of solvent during use, contact Daubert Chemical Company. DO NOT THIN TECTYL 155FF Pigmented. Incorrect thinning will affect film build, dry time and product performance. Daubert Chemical Company recommends that the ambient and product temperature be 50 - 95F (10 - 35C) at time of application. TECTYL 155FF Pigmented can be airless spray applied.
TECTYL 155FF Pigmented can be removed with TECTYL HPS solventborne thinner, vapor degreasing, hot alkaline wash, or low pressure steam. TECTYL 155FF Pigmented can be removed from fabrics by normal dry cleaning procedures. Avoid the use of chlorinated or highly aromatic solvents when removing from painted surfaces, as these solvents may adversely affect paint.
Store TECTYL 155FF Pigmented at temperatures between 50-95°F (10-35°C). Mild agitation is recommended prior to use.
Adequate ventilation is required for cure and to ensure against formation of a combustible liquid. THE PARTIALLY CURED FILM SHOULD NOT BE EXPOSED TO IGNITION SOURCES SUCH AS FLARES, FLAMES, SPARKS, EXCESSIVE HEAT, OR TORCHES. Refer to Daubert’s Material Safety Data Sheet for additional handling and first aid information.
The addition of any product over or under this coating is not recommended. The use of additional coatings could result in chemical incompatibility, thus adversely affecting the performance of this coating as stated in the lab data section. If a product other than Daubert Chemical Company's recommended product is required, written authorization must be obtained from Daubert Chemical Company, Inc.
If you don't see what you are looking for, give us a call.