QC Lubricants
CAGE CODE 9Y364
7360 Milnor St. Philadelphia, PA 19136
(215) 333-4187
Direct Line

Toll Free
With Extension (800) 887-2436
For Technical Assistance:
Dial Extension 203 for Stan Jakubowski
For Sales:
Dial Extension 211 for Lu Ann Quinn or 224 for Lindsay Romero
Email Lu Ann Quinn  ♦   Email Lindsay Romero


Home

We actively supply a comprehensive line of MIL-SPEC  and commercial lubricants.

 

Products
Mil-Specs
MSDS
PDS and Other Docs
Product Shelf Life

QC BLU DEF Diesel Exhaust Fluid

 

advanced

RONEX™ MP

 

RONEX™ MPExxon Ronex MP14 oz. Cartridges

Grease

Product Description

RONEX™ MP is a lithium complex, mineral oil based multipurpose grease that can be used in a wide range of automotive and industrial applications. RONEX MP grease has good performance over a wide temperature range, and provides moderate load carrying, extreme pressure properties, water resistance, oxidation stability, and rust and corrosion protection. It is NLGI GC-LB qualified for use as a wheel bearing and chassis grease.

 

Features and Potential Benefits

RONEX MP offers the following features and potential benefits:

  • Excellent resistance to high temperature degradation for long service life helping to extend grease lubrication intervals.
  • Enhanced extreme-pressure and anti-wear properties helps protect moving surfaces from wear; leading to extended component life.
  • Excellent high- and low-temperature performance helps minimize cold-weather dispensing problems.
  • Good water-resistance properties for reliable grease performance in hostile aqueous environments.

Applications

RONEX MP is a multi-purpose grease recommended by ExxonMobil for both industrial and automotive applications such as:

  • Industrial - Plain and rolling element bearings, gears
  • Automotive – Light Truck, Bus and Construction applications requiring an NLGI GC-LB qualified grease such as:
    o    Wheel Bearings
    o    Ball Joints
    o    Chassis lubrication points

 

Specifications and Approvals

RONEX MP meets or exceeds the requirements of: RONEX MP
NLGI GC/LB X
DIN 51825: (2004-06) KP2K-30L

RONEX MP has the following builder approvals: RONEX MP
FORD WSS-M1C267-A1 X

Typical Properties

RONEX MP  
NLGI Grade 2
Thickener Type Li-Complex
Color, Visual Green
Penetration, Worked, 25ºC, ASTM D 217 280
Dropping Point, ºC, ASTM D 2265 280
Mineral Oil Viscosity, ASTM D 445  
cSt @ 40ºC 115
4-Ball Wear Test, ASTM D 2266, Scar, mm 0.5
4-Ball Weld Load, ASTM D 2596, Kg 250
Timken OK Load, ASTM D 2509, lb 45
Corrosion Prevention, ASTM D 1743 Pass
Rust Protection, IP 220, Distilled Water 0-0
Copper Strip Corrosion, ASTM D 4048 1A

Health and Safety

Based on available information, this product is not expected to produce adverse effects on health when used for the intended application and the recommendations provided in the Material Safety Data Sheet (MSDS) are followed. MSDS's are available upon request through your sales contract office, or via the Internet. This product should not be used for purposes other than its intended use. If disposing of used product, take care to protect the environment.


All trademarks used herein are trademarks or registered trademarks of Exxon Mobil Corporation or one of its subsidiaries. 

Copyright © 2001-2014 Exxon Mobil Corporation. All rights reserved.

back to Exxonmobile main page