QC Lubricants
CAGE CODE 9Y364
7360 Milnor St. Philadelphia, PA 19136
(215) 333-4187
Direct Line

Toll Free
With Extension (800) 887-2436
For Technical Assistance:
Dial Extension 203 for Stan Jakubowski
For Sales:
Dial Extension 211 for Lu Ann Quinn or 224 for Lindsay Romero
Email Lu Ann Quinn  ♦   Email Lindsay Romero


Home

We actively supply a comprehensive line of MIL-SPEC  and commercial lubricants.

 

Products
Mil-Specs
MSDS Boeing Specs McDonnell Douglas Specs
QC BLU DEF Disel Exhaust Fluid

ExxonMobile
Castrol
Shell
Valvoline
Anderol
LHB Industries
 


advanced

 Tectyl 300G HF Black 

QC Lubricants carries Tectyl 300G HF Black in pails and drums.  TECTYL

Description
TECTYL 300G HF BLACK is a waterborne corrosion preventive coating that possesses a volatile organic content (VOC) of 2.9 lbs. per gallon and a flash point >212F (100C). The cured film is hard and flexible. TECTYL 300G HF BLACK provides an effective barrier against corrosive environments for ferrous and non-ferrous fabrications and industrial components. TECTYL 300G HF BLACK is suitable for use within environments that require coatings to possess higher flash points and lower VOC standards.

Surface Preparation
The maximum performance of TECTYL 300G HF BLACK can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale. Daubert Chemical Company recommends that the metal substrate temperature be 50-95F (10-35C) at the time of product application.

Application
TECTYL 300G HF BLACK is formulated to be used as supplied. Ensure uniform consistency prior to use. Continued stirring is generally not required. If the product thickens due to cold storage or loss of water and coalescing solvent during use, contact Daubert Chemical Company. DO NOT THIN TECTYL 300G HF BLACK. Incorrect thinning will affect film build, dry time and product performance. Daubert Chemical Company recommends that the ambient and product temperature be 50 - 95F (10 - 35C) at time of application. TECTYL 300G HF BLACK can be airless spray or dip applied. DO NOT FREEZE TECTYL 300G HF BLACK
 
Removal
The dry film is not normally intended for removal. The product can be stenciled over after the film is cured. Tectyl WBS-A, citrus or alkaline cleaner will remove fresh residue accumulated on application equipment. If removability is a factor, contact Daubert Chemical Company and samples should be evaluated prior to application.

Storage
Store TECTYL 300G HF BLACK at temperatures between 50-95F (10-35C). Mild agitation is recommended prior to use.

Caution
Adequate ventilation is required for cure and to ensure against formation of a combustible liquid. THE PARTIALLY CURED FILM SHOULD NOT BE EXPOSED TO IGNITION SOURCES SUCH AS FLARES, FLAMES, SPARKS, EXCESSIVE HEAT, OR TORCHES. Refer to Dauberts Material Safety Data Sheet for additional handling and first aid information.

Note:
The addition of any product over or under this coating is not recommended. The use of additional coatings could result in chemical incompatibility, thus adversely affecting the performance of this coating as stated in the lab data section. If a product other than Daubert Chemical Company's recommended product is required, written authorization must be obtained from Daubert Chemical Company, Inc.
TECTYL 300G HF BLACK

Back to Tectyl Main Page

If you don't see what you are looking for, give us a call.