QC LubricantsCAGE CODE 9Y364
7360 Milnor St. Philadelphia, PA 19136
(215) 333-4187 Direct Line
Toll Free With Extension (800) 887-2436
For Technical Assistance: Dial Extension 203 for Stan Jakubowski
For Sales: Dial Extension 211 for Lu Ann Quinn or 224 for Lindsay Romero
Email Lu Ann Quinn ♦ Email Lindsay Romero
We actively supply a comprehensive line of MIL-SPEC and commercial lubricants.
QC Lubricants carries Tectyl 810 in pails and drums.
The maximum performance of Tectyl 810 can be achieved only when the metal surfaces to be protected are clean, dry, and free of rust, oil, and mill scale. Daubert Chemical Company recommends that the metal substrate temperature be 50 - 95°F (10 - 35°C) at the time of product application.
TECTYL® 810 is primarily applied in water emulsions in 5 to 25 percent concentrations. Proper concentrations of TECTYI2' 810 should be evaluated before implementing its use. Consult Daubed Chemical , Company for further information. TECTYL® 810 may be used in recirculating systems at 40 - 120° F (4 - 49°C). When mixing, always add the oil to the water with the oil and water at 70 - 90°F (21 - 32°C).
Tectyl 810 can be removed if necessary with TECTYL® HPS solventborne thinner, vapor degreasing, or standard hot alkali systems.
Refer to Daubert’s Material Safety Data Sheet for health and safety information
The addition of any product over or under this coating is not recommended. The use of additional coatings could result in chemical incompatibility, thus adversely affecting the performance of this coating as stated in the lab data section. If a product other than Daubert Chemical Company's recommended product is required, written authorization must be obtained from Daubert Chemical Company, Inc.
If you don't see what you are looking for, give us a call.