QC Lubricants
CAGE CODE 9Y364
7360 Milnor St. Philadelphia, PA 19136
(215) 333-4187
Direct Line

Toll Free
With Extension (800) 887-2436
For Technical Assistance:
Dial Extension 203 for Stan Jakubowski
For Sales:
Dial Extension 211 for Lu Ann Quinn or 224 for Lindsay Romero
Email Lu Ann Quinn  ♦   Email Lindsay Romero


Home

We actively supply a comprehensive line of MIL-SPEC  and commercial lubricants.

 

Products
Mil-Specs
MSDS Boeing Specs McDonnell Douglas Specs
QC BLU DEF Disel Exhaust Fluid

ExxonMobile
Castrol
Shell
Valvoline
Anderol
LHB Industries
 


advanced

 Tectyl 603  

QC Lubricants carries TECTYL 603 in pails and drums.  TECTYL

Description
TECTYL 603 is a polymeric, water emulsifiable corrosion preventive. It is specially formulated for coating phosphated and painted parts such as hinges, bolts, screws, brackets, fasteners, etc. It contains a special additive system which provides a durable, self-healing, corrosion resistant film. The concentrated coating is an amber liquid. The cured film is clear and transparent.

Benefits
Easy Application TECTYL 603 is applied as a water emulsion. It is normally applied in a dipping operation. Long-Term Protection TECTYL 603 deposits a self-healing film on phosphated parts and components that provides salt spray protection superior to conventional water soluble rust preventive oils. Phosphated parts coated with an emulsion of 20 percent TECTYL 603 and 80 percent water will pass the 240 hour salt spray test requirement of the General Motors 6035-M phosphating specification. The maximum protection of TECTYL 603 can only be obtained when applied to properly phosphated components. TECTYL 603 will not compensate for inadequate phosphating. Adequate phosphating per the General Motors 6035-M specification is 2,000 - 3,000 milligrams of zinc phosphate per square foot of coating area.

Application
1. Charge tank with de-ionized water.
2. Begin mixing and bring water temperature to 140 - 160F (60 - 71C).
3. Add TECTYL 603 slowly, with agitation, to develop a 20 percent emulsion. WHEN MIXING, ALWAYS ADD TECTYL 603 TO THE WATER, NEVER IN REVERSE ORDER.
4. The TECTYL 603 emulsion temperature at the time of initial fill and application should be 140 - 160F (60 - 71C).
5. Mechanical agitation (not air) is required at all times

System Maintenance
A properly maintained system is important for optimum performance. To ensure proper protection, the pH and emulsion concentration of TECTYL 603 should be checked at least once daily. Refer to Technical Bulletin #29 for complete information regarding maintenance and handling procedures.

Caution
Refer to Daubertís Material Safety Data Sheet for health and safety information

Note:
The addition of any product over or under this coating is not recommended. The use of additional coatings could result in chemical incompatibility, thus adversely affecting the performance of this coating as stated in the lab data section. If a product other than Daubert Chemical Company's recommended product is required, written authorization must be obtained from Daubert Chemical Company, Inc.
Tectyl 603

Back to Tectyl Main Page

If you don't see what you are looking for, give us a call.