QC Lubricants
CAGE CODE 9Y364
7360 Milnor St. Philadelphia, PA 19136
(215) 333-4187
Direct Line

Toll Free
With Extension (800) 887-2436
For Technical Assistance:
Dial Extension 203 for Stan Jakubowski
For Sales:
Dial Extension 211 for Lu Ann Quinn or 224 for Lindsay Romero
Email Lu Ann Quinn  ♦   Email Lindsay Romero


Home

We actively supply a comprehensive line of MIL-SPEC  and commercial lubricants.

 

Products
Mil-Specs
MSDS Boeing Specs McDonnell Douglas Specs
QC BLU DEF Disel Exhaust Fluid

ExxonMobile
Castrol
Shell
Valvoline
Anderol
LHB Industries
 


advanced

 Tectyl 282

 Tectyl 121BN

TECTYL 282 is a water displacing, solvent cutback, oil concentrate corrosion preventive compound, lubricant, and penetrant. The film is oily, transparent, and non- staining. TECTYL 282 is used in its diluted form to protect ferrous and non-ferrous industrial parts and transportation components.

Surface Preparation
The maximum performance of TECTYL 282 can be achieved only when the metal surfaces to be protected are clean, dry, and free of rust, oil, and mill scale. Daubert Chemical Company recommends that the metal substrate temperature be 50 - 95F (10 - 35C) at the time of product application.

Application
Ensure uniform consistency prior to use. TECTYL 282 is designed to be diluted 1 to 4 with mineral spirits. Always add the solvent to the TECTYL 282 concentrate; never add TECTYL 282 concentrate to pure mineral spirits. Continuous stirring or thinning is generally not required. Daubert Chemical Company recommends that the ambient and product temperature be 50 - 95F (10 - 35C) at time of application.

Removal
TECTYL 282 can be removed with TECTYL HPS solventborne thinner, vapor degreasing, hot alkaline wash, or low pressure steam. TECTYL 282 can be removed from fabrics by normal dry cleaning procedures. Avoid the use of chlorinated or highly aromatic solvents when removing from painted surfaces, as these solvents may adversely affect paint.

Caution
Adequate ventilation is required for cure and to ensure against formation of a combustible liquid. THE PARTIALLY CURED FILM SHOULD NOT BE EXPOSED TO IGNITION SOURCES SUCH AS FLARES, FLAMES, SPARKS, EXCESSIVE HEAT, OR TORCHES. Refer to Daubertís Material Safety Data Sheet for additional handling and first aid information.

Note:
The addition of any product over or under this coating is not recommended. The use of additional coatings could result in chemical incompatibility, thus adversely affecting the performance of this coating as stated in the lab data section. If a product other than Daubert Chemical Company's recommended product is required, written authorization must be obtained from Daubert Chemical Company, Inc. Tectyl 282

Back to Tectyl Main Page

If you don't see what you are looking for, give us a call.